Log Milling Jig

A cost-effective template for creating dovetail corner and wall joints for log houses - with just a router!

• Easily create airtight, double dovetail wood connections.
• Suitable for smooth or profiled wooden beams.
• Work safely. The router hooks securely into the routing guide. 
• No expensive, special machines needed!
• Easy to transport to job sites.
• High quality craftsmanship.

Modular system

• Make other other tenon shapes and sizes by changing the base plate.
• Other components are interchangeable.
• Supplied in an convenient systainer with foam insert
• Suitable for smooth or profiled wooden beams.

Components:

Milling jigs: Tenon template and variably adjustable hole template made of anodized aluminum and bushings made of stainless steel that can be replaced when worn.

Scales: Made of black anodized aluminum with light engraving for high reading contrast, resistant to solvents and mechanical stress.

Milling guide: The router is hooked into the patented safety routing guide with the locking plate. This allows you to work safely and without tiring.

Locking plate: Made of plastic, screwed onto the soleplate of the router.

Setting gauge: The tenon length is set with the setting gauge. The milling cutter diameter, the race diameter, the tenon length and the hole depth can also be measured.

Horizontal stop: has a fixed angle of 90 degrees, which is used to set the beam height.

Vertical stop: has a fixed angle of 90 degrees so that the beam width can be adjusted.

Chip protection: The horizontal chip guard is clipped onto the spigot template from above. The vertical chip protection is pushed from above into the guide groove of the milling guide on the spigot template.

Clamp fixation: For quick fixation of the tenon template on the beam, with a lever clamp.

Cutter: Milling cutter with reversible blade and race. It is attached with a double-threaded nut directly into the conical shank of the router. Adapters are available for some routers without a conical shank or with a different tool holder.

Variable tenon lengths

By changing the bearing ring, 3 different tenon lengths can be milled.

• 28mm
• 25mm (standard tenon length)
• 20mm

Suitable for the following routers:

• Mafell LO65
• Festool OF2200
• Festool OF1400
• Scheer HM16-HM25
• DeWalt 625 / 626
• Makita RP2300
• Bosch GOF2000
• Other models on request

Sizes

• Beam width 6-12cm
• Beam height 6-24cm
• Tenon angle 10 degrees

• Beam width 10-18cm
• Beam height 6-24cm
• Tenon angle 10 degrees

Packages

Packages are assembled according to application and budget:

• Occasional or professional use
• Components needed
• Depending on the router, there are different locking plates and cutters, so the configuration and prices may vary.
• Contact us for a quote!

Example packages: